What is the reason for floor bulge and how to solv

2022-07-22
  • Detail

Many families now choose to decorate with wooden floors when decorating the ground. Because compared with ceramic tiles or marble, the wooden floor will be warmer and will not look cold. But some friends report that the wooden floor will appear bulging after being used for a period of time. What is the reason for the bulging of the floor? How to solve it? Now let's learn about it with Xiaobian

when decorating the ground, many families now choose to decorate with wooden floors. Because compared with ceramic tiles or marble, the wooden floor will be warmer and will not look cold. But some friends report that the wooden floor will appear bulging after being used for a period of time. What is the reason for the bulging of the floor? How to solve it? Now let's learn about it with Xiaobian

1. What is the reason for the floor bulge

a. the base course is not treated well: before the installation of the wooden floor, the ground is easy to become relatively rough if there is sand on the ground is not cleaned. Moreover, after the floor is installed, the moisture-proof membrane and the balance layer on the back of the floor will be damaged in the process of trampling, and the moisture on the ground will cause the floor to bulge

b. It is caused by improper treatment of moisture-proof measures in daily life: if the moisture-proof membrane connection of the wet ground is not tightly adhered with waterproof tape, and the floor is in a wet environment for a long time, then after the balance layer is eroded by moisture, moisture may enter the floor, causing damage to the floor and causing bulging

c. It is caused by no reserved gap when paving the floor: the floor ignores the principle of thermal expansion and cold contraction in the process of paving, and expands after being exposed to moisture in the use of the floor, which is also a major factor in what causes the floor bulge. Because there is no gap reserved in advance, there is a bulge on the floor surface

2. How to solve the floor bulge

a. Before paving the wooden floor, we must ensure that the moisture content does not exceed the standard. Too high moisture content will cause deformation and warping of the floor; However, if the moisture content is too low, it will produce the phenomenon of bagging. Therefore, it should be moderate

b. In the process of decoration, make sure that the glue completely fills the joints. If it is not filled, it is easy for water to enter from the joints with less glue when dragging the floor, and the floor substrate will absorb water, resulting in local expansion and blistering

c. When replacing a new floor, the best way is to remove the deformed floor block, then pave the ground with cement, and then replace it with a new floor, so that the floor will be flat as before

d. The wooden joist should be connected with the hole slot and the vent on the floor surface. There should be no less than two vents on the floor surface and no less than two vents on each side of the baseboard, so as to facilitate the circulation of air

Xiaobian conclusion: the above is an introduction to the causes of floor bulge and how to solve it in home decoration. I hope it can help you. At the same time, I hope you can pay attention to these small details and deal with them in time to avoid more serious situations on the floor in the future, which will be more troublesome

苏州男科医院

沈阳癫痫医院

常州男科医院

贵阳精神医院

Copyright © 2011 JIN SHI